carry out maintenance, replace lamps, remove filters, clean the extractor hood without removing the
plug from the mains socket;
operate the extractor hood with an open fire source, open gas burners or heating elements.
Heating
elements should be always covered with dishes;
prepare food with use of alcohol;
leave the fryer unattended;
operate the extractor hood with removed filters;
connect the extractor hood to the electric network of the cooker, cut the socket of the electric cord while
installing.
ATTENTION! IT IS FORBIDDEN TO USE GAS (ELECTRIC) COOKER IF THE EXTRACTOR
HOOD IS TURNED OFF.
4.2.
In order to avoid damage by electric current, the extractor hood must be plugged into a grounded outlet.
4.3.
The extractor hood connected to the separate ventilation shaft. It is forbidden to connect other
appliances to the same ventilation shaft.
4.4
. Using the extractor hood together with other heating appliances (gas, oil, ovens, etc.), besides electric,
it
is necessary to provide the premises, it which the extractor hood is installed with the additional flow of
the fresh air (for example to open the window).
4.5.
For air extraction to the chimney use air duct
Ø150 / 120mm
. A smaller diameter will create additional
air resistance, which will increase noise and vibration, as well as motor overheating.
4.6.
Provide timely cleaning of non-disposable aluminum removal filters, otherwise, the efficiency of the
extraction will decrease and there will be a fire hazard due to the accumulation of grease and dust in the filter.
4.7.
It is forbidden to turn on the extractor hood in case of ignition with the purpose of reduction of smoke
until complete localization of fire.
4.8.
In case of ignition under the extractor hood, cover the fire with a thick cloth, disconnect the extractor
from the electric network, do not use water to extinguish a fire in the places where the electrical appliances are
located.
4.9.
Protect the cord for connection to the electric network from the mechanic and thermal damages.
5. EXTRACTOR HOOD DESCRIPTION
5.1.
The appliance
«GZ-443»
is an air purifying device of the exhaust type with a diameter fan (turbine),
completed with a grease picking aluminum filter. It is manufactured from sheets of carbon steel with a
decorative protective coating of powder paints
.
5.2
The cooker hood refers to the type of “
built-in
” cooker hoods and is built into the kitchen furniture set
on the wall above the cooker.
5.3.
Depending on the installation scheme over the cooker, the extractor hood can work in two variants
(see
item 1.5):
- in the mode of air extraction into the chimney of the kitchen
(pic. 1).
- in the recirculation mode
(pic. 2)
(closed circular air circulation in the kitchen).
Distance H:
To electric cooker 65-75cm
To gas cooker 75-85cm
“It is necessary to consider, that when the extractor hood is
on, the pressure is automatically lowered in the enclosed
room, and should be balanced with an inflow of fresh air.
This may be achieved by opening doors and windows or
with use of equipment for special inflow ventilation”.
Pic. 1
Pic. 2
Summary of Contents for GZ-443
