25
.............................
CCEC/ OM Manual GlasStile GSS 1.6 EN
07
.2009
Programming the Wing ‘Home Position’
Select a position, using the
POS
switches on the programming unit.
Place the panel in the desired position, manually.
Press the
SET POS
button. The green lamp will flash in acknowledgement.
Repeat this process for the next position as required.
Always end by selecting
POS 0
on the programming unit.
Programming Options
Set by pressing the relevant buttons to the required settings.
When everything has been set as desired, press the
SEND
button. The information is then sent to the
gate and the green lamp on the Hand Held Programmer flashes in acknowledgement. Make sure that
the green lamp flashes otherwise the settings will not be confirmed.
End Programming
Press
PRG.
The brake is applied.
If any settings have been made which affect the home position of any of the panels an automatic
search is now made.
Testing after Installation
When the installation is complete, test the system. The GlasStile GSS will now search for a zero
position (INDEX 0). Do not interfere with the gate until this has been achieved and the brake has
been activated in the home position.
Allow the un
it to calculate and store its stopping distances by pressing ‘
PRG
’ followed by ‘
T
’ from
the mode options, then press
SEND
and finally
‘PRG’
. A ten minute test procedure will start, once
you exit the Program Mode.
Important note; the wing on the GlasStile should not be touched or interfered with during
this teaching procedure
Should the GlasStile GSS not operate as desired, carry out the following
checks…
Press ‘
PRG’
.
Make a note of the current settings from the Hand Held Programmer.
Select mode ‘
DF
’, followed by
SEND
.
Exit the programming mode by pressing ‘
PRG
’.
Adjust the gate panels home position and settings as described in this manual.
Return to the procedure detailed above and repeat the set-up with new settings. This should also
include the Home Position settings plus ten minutes test etc.
