GUIDO RAYOS X NESTORET 5050, Manual, Page: 26 / 60

GUIDO RAYOS X, S.A.
NESTORET 5050
26
MAN-011
Feb. 01
Ed. 2 / Rev. 1
III. MAINTENANCE
III.1 CABINET
The cabinet can be cleaned with a damp cloth and soap. It must be dried immediately
afterwards.
III.2 FILTER
The filter should be replaced every three
months. Pull gently from the Up to 100%
Oxygen inlet and press it gently towards
the Incubator side until the panel can be
removed. Remove the filter pads and
replace with the new ones. Replace the
panel and apply the self-adhesive tab
(from the filter instruction sheet) to the
face of the panel. Note the date of repla-
cement of the filter pads on the tab.
III.3 HOOD
The hood can be removed from the body loosening the four thumb screws which hold
the bed spacers in place. Loosen the thumb screws, disengage the bed spacers from the
hood, disengage the two screws from the sensor housing and carefully remove the hood.
ATTENTION: B
EFORE PROCEEDING
,
UNPLUG THE
T
EMPERATURE AND
A
IR
/H
UMIDITY
S
ENSORS
A
SSEMBLY LOCATED AT THE LEFT SIDE OF THE
H
OOD
.
O
NCE CLEANED
,
PLUG IT AGAIN
.
The hand hole doors can be replaced by unscrewing the hinge pin and removing the
door.
The hood can be cleaned with soap and water. Accepted desinfectants such as
Wescodyne, Warexin, etc., may be used. NEVER use ether, alcohol or acetone to clean
the hood.
Dusting
Dust and clean hood with a soft, damp cloth or chamois. Wipe the
surface gently. DON'T use gritty cloths.
Washing
Wash with mild soap or detergent and water. DON'T use scouring
compounds.
Use plenty of water. Apply to large areas with a bristle mop (such as