GUIDO RAYOS X NESTORET 5050, Manual, Page: 25 / 60

GUIDO RAYOS X, S.A.
NESTORET 5050
25
MAN-011
Feb. 01
Ed. 2 / Rev. 1
for LCD equipment press 1; for luminiscent display press 2.
II.9. ON/OFF SWITCH (SW) ACTIVATION
Press 0 key when applications programm is selected. The display will show:
WITH ON/OFF
WITHOUT ON/OFF
For equipments with ON/OFF switch on front panel keypad, press the ON/OFF key,
selecting WITH ON/OFF option.
II.10. CHANGE OF TEMPERATURE ALARM RANGE (HIGH /
LOW)
Press 4 key when applications programm is selected. The display will show:
RNG.TMP (0.1 ÷ 2.0)
R= __._ , H=
Preset value of temperature Range (R) (High / low) is 1 ºC. To this value corresponds a
hysteriris value (H) of 0,4 ºC.
To change the preset value (R) (between 0,1 ºC and 2,0 ºC), by means of the numerical
keypad, set the required value and press ENTER, the display will show the
corresponding hysteresis value (this value H can not be changed).
Then press ENTER again to accept the new values (R) and (H).
those used in window washing) and to smaller areas with a clean, soft
cloth, sponge, or chamois. DON'T use boiling water. DON'T use strong
solvents such as ether.
Drying
If it is necessary to dry the washed surface, use a clean damp
chamois. DON'T rub hood with a dry cloth.
III.4 BED TRAY
The bed tray can be autoclaved at 15 p.s.i. (1.05 kg/cm2) for 20 minutes. It must be
laid upside-down on a flat surface during sterilization to prevent distortion.