GUIDANCE MARINE CyScan, Installer'S Manual

Page: 27 / 62

l
27
Network Communication Settings
The Network Config tab of the CSI is used to view and amend the CSI’s definition of its
communications link with the sensor, and to reconfigure the sensor’s own communications
settings (e.g. from Serial to Ethernet mode).
To Modify the CSI’s Communications Settings
1. Click on the Network Config tab of the CSI.
2. Click on the Disconnect button if the CSI is connected to the sensor.
3. Click on the Edit button.
4. Alter the settings as required.
5. Click on
Apply to save the changes or on Cancel to discard.
To Modify the Sensor’s Communications Settings
1. Contact Guidance Marine and obtain a new sensor network configuration file ( connect.ini ).
2. Click on the Take Command button if the CSI is not already In Command mode.
3. Click on
Browse
.
4. Locate the
connect.ini
file within the
Select a sensor network configuration file
window
and click on Open .
5. Click on Send to Sensor .
6. You will now be prompted to reboot the sensor so that the new configuration can be
applied. Click on Yes in the File Sent Successfully window.
7. Modify the CSI’s and Dashboard’s communications settings if necessary to match the new
sensor settings (see left side of page).
8. Leaving at least 30 seconds after step 6, click on the Connect button.
To Modify the Dashboard’s Communications Settings
The Dashboard’s communications settings are established during installation. In order to
modify them:
1. Uninstall the Dashboard.
2. Install the Dashboard and amend the settings when they are presented.
See
page 23
and
page 24
for details about uninstalling and installing the Dashboard.