GUDEL CP 3-5 V2, Operating Manual

Page: 199 / 350

Install the guideway as follows:
1 Clean the reference surfaces and guideways thoroughly and rub a sharp-
ening stone across them
2 Clamp guideways to reference surfaces with screw clamps
3 Tighten all screws
4 Checking the transition: Gap dimension < 0.02 mm
5 Use a suitable measuring instrument to check that the guideways are par-
allel
(Tolerance: ±0.04 mm)
6 Move the carriage or axis across the entire length:
The drive pinion with correctly set tooth flank backlash should not jam at
the transitions of the guideway
7 If deviations of the transition or parallelism occur:
7.1 Remove the screws and guideways
7.2 Repeat the procedure
The guideway has been installed.
Final tasks
Perform these final tasks as follows:
1 Move the carriage along the axis, if necessary
2 Retract the vertical axis, if necessary
3 Remove the slings
4 Set the rollers and the tooth flank backlash
Ü 2
207
The final tasks have been performed.
Maintenance OPERATING MANUAL CP 3-5 V2
9007202252815371_v1.0_
EN-US
199