Transportation and Storage
At transportation, the unit has to be secured against
falling or swooping
At storage, it is necessary that the unit
is stored at a dry place inaccessible to children and
unauthorised persons
Before a long shut down, clean the unit thoroughly .
Assembly
Protection Cover Assembly (Fig. B+C)
Pull the protection cover on the column
(Fig. B)
. in the
direction of the string head
(Fig. C)
. Secure the cover by
tightening the screw and the nut . Use a socket spanner
included .
Handle Assembly (Fig. D+E)
Put the handle on the column
(Fig. D
). Fasten with a screw
and a clamping knob
(Fig. E)
.
Shoulder Strap Suspension (Fig. F)
Suspend the shoulder strap from the buckle
(Fig. F).
Appropriate Use
The unit has been designed for mowing lawns and small
grass areas around a house and private gardens. The units
for private gardens are the units not presumed for use in large
facilities, parks, sports grounds, streets and in agriculture and
forestry. Observation of the manufacturer’s instructions for
use is the premise of appropriate use of the unit. .
Caution! In view of personal and material damage,
the unit should not be used for pulverising for
composting .
Putting in Operation (Fig. G+I+J)
The unit is designed for mowing . There is a semiautomatic
system of the string extension. Any time the semiautomatic
system of string extension is used, the string will get
extended automatically so that you are mowing with an
optimum width of mesh. Knock the unit slightly against the
ground. Account for the wear of the string extension getting
increased owing to the frequent use of the automatic
system.
Notice: At first putting in operation the excessive end of
the string will be shortened with the protection cover
sharp edge. If the string is too short , push the button
on the reel and pull the string out strongly. At the first
start up, the string will shorten to an optimum length .
To keep the maximum output of your unit, the following
instructions should be observed : Do not use the unit
without protection facility. Do not mow, of the grass is wet .
The best results shall be reached on dry grass . Connect
the power cable to the extension one and hang it on the
handle. To switch the unit on, shift the switch lock forward
first and then switch the on/off switch To switch the unit off,
let it go again. . Now, put the unit close to the grass if the
switch is pushed. i.e. if it is in operation. To mow correctly.
Lean the unit to the side and proceed forward. Hold the unit
leaned ca 30°
(see Fig. J)
. On long grass, the grass should
be shortened by steps from the top
(see Fig. I)
. Use the
edge guide and the protection cover to avoid excessive
wear of the string . Prevent the contact of the unit with hard
articles to prevent an excessive wear of the string .
Notice ! After pushing the on/off switch , it will take
some 1-2 seconds to reach the maximum speed. In the
course of the work, the motor speed may vary . That is
because the speed will adjust to the load.
String Reel Replacement (Fig. H)
Caution!
Before replacing the string reel (Fig.), it is
necessary to unplug! Release the fastening screw
anticlockwise. Remove the reel. Pull the ends of a new reel
through the loop and put the reel in. . Fasten the fastening
screw clockwise. Caution! The strung end of the nylon
string may cause injury.
Maintenance and Care
Before putting the unit aside and cleaning it, switch the unit off
and unplug. Remove the sediment on the protection cover
with a brush. Clean the plastic body and parts with usual
detergent and soft cloth. Do not use any aggressive cleaners
or solvents for cleaning .Never spray water on the unit.
Prevent any water intrusion in the unit.
Faults
The unit will not run:
Check the supply cable if it is
connected properly and check the fuses. If the unit does not
work despite the voltage being correct, send it kindly to the
customer servicing at the shown address.
