Screw the closing nut on the connecting tread (left
thread) – put the protective cover on.
Connect the new cylinder and check tightness.
Start up procedure / discontinuation or stopping procedure of
the catalytic stove:
Before operation, let the cylinder stand in a vertical
position for 1 hour if transported so the elements
more burdening to the environment may settle down
to the bottom of the cylinder.
Place the gas cylinder to the inner space of the
device (back side). Connect the gas cylinder as
described above.
Open the cylinder valve on the propane cylinder by
turning to the left.
Push the large setup button down and turn it to the
large flame symbol – start.
Push the piezo-ignition button several times, to light
the starting flame. When the starting flame is visible,
keep the setup button pushed for about 20 seconds,
heating up the thermal element. You can release the
setup button afterwards and the heating is turned on
to the highest level. If the starting flame goes off,
though, repeat the procedure.
The heating output can be lowered by pushing lightly
on the setup button and turning it to the medium or
minimum flame symbol. We recommend to wait for 10
minutes after starting the operation before changing
the heating output.
The catalytic gas plate is slightly hot only in the area
of the starting flame, but the full heating output is
spread over the whole catalytic plate.
The slight smoke (fresh paint) will dissipate after
heating up.
CAREFUL! Do not move when hot (transport).
The gas cylinder must not be turned during the
operation or shut down of heating device. The highest
danger of accident!
Shutting off of the catalytic gas heating device:
CLOSE THE GAS VALVE ON THE CYLINDER.
Illustration 3:
The devices are supplied with an electric heating ventilator
allowing for an increase of 2 x 1000 W as an addition to
the regular gas burning by the device.
Electric power supply cable (rolled up inside the
device) (1) should be connected to a socket of 230V-
50Hz.
Push the heating ventilator switch. There are 4
positions of the switch: (2)
= ventilator off
= ventilator only
= vent 1000 W
= vent 2000 W
Inspection and maintenance
Any dirt on the case of the device can be cleaned off
with a wet towel. Water must not get onto the surface
of the catalytic burner.
Do not use any abrasive cleaning means or solvents
for cleaning.
In case of a longer discontinuation of use, disconnect
the gas cylinder and place it outside of the device,
store the device in a dust-free environment.
Contact your contractual sales point for more
extensive maintenance.
Use only original spare parts for repairs.
Such maintenance should be performed at least once
every 2 to 3 years.
0
*
~
~
~
13
