Technical data
Operating pressure:
6,3 bar
Air consumption:
130-850 l/min
Air connection screw:
1/4"
Max. Torque:
110 Nm
Max.speed:
180 min
-1
Extensions (SW in mm): 10, 11, 12, 13, 14, 15, 17, 19, 21,
22, 24, 27, 1 x extension 75 mm,
1 adapter to ½“, 1 adapter to
3/8“ 1 cross joint ½“.
Weight 1,2
kg
Noise data LWA:
96 dB
Recommended hose Cross-section : 10mm
Initial Operation
Screw the plug-in clutch included in the delivery (pos. 2)
screw in the reduction clutch. Use a box-end or a forked
wrench for it.
Notice: Tighten the thread with a Teflon tape.
Pull a required socket wrench insert on the drive (pos.4).
Connect the air hose and a fast-acting clutch to the plug-in
clutch. Put the socket wrench insert on the screw or the
nut being released/tightened. Set-up the required direction
of turning on the switching lever (Fig.2) and pull the draw-
off lever (pos. 3).
The required speed and torque may be set up with a screw
on the hand grip (Fig. 3).
Maintenance and Care
Observing warning commands shown in the Lasting and
trouble-free function of your ratchet screwdriver is
grounded on regular lubrication. Use only a special tool oil.
Pick up a possibility of lubrication.
a) Via a beam added lubricator
The full maintenance unit include a beam added lubricator
and is placed on the compressor.
b) Via a lubricator on the piping
A lubricator installed on piping supplying the unit with
sufficient amount of oil in an immediate distance from the
unit (approximately 50 cm).
c)
manually
If there is no maintenance unit or a lubricator on piping, 5-
6 drops of oil should be put in pneumatic connection
before every putting in operation. Store the pneumatic tool
in dry rooms.
14
Summary of Contents for 75145
Page 2: ...1 2 3 4 1 2 3 6 9 5 8 7 2 ...
