11
ADICOS HTL-2
410-2410-008 EN20
PUTTING INTO OPERATION
6
Putting into operation
DANGER!
Risk of fire due to active hot plate
The ADICOS HTL-2 uses an active hot plate and can cause fires and explosions
if used improperly.
−
Operate the device only if you have a permit for hot work!
−
Do not operate the device in areas where there is danger
of explosion!
−
Do not leave an activated device unsupervised!
DANGER!
Burns due to active hot plate
The ADICOS HTL-2 uses an active hot plate that can cause severe burns if it
comes into contact with the skin.
−
Do not touch the hot plate!
−
Do not operate the device in the carrying case!
DANGER!
Fire hazard due to deposits
Deposits in the test tube of the ADICOS HTL-2 (e.g. carbon dust) can ignite
during operation.
−
Clean the device before each use!
Check charge status
Before you mount the SOLO 760 battery baton, you must check the charging
status of the batteries located inside.
−
If needed, charge the batteries according to the
manufacturer‘s instructions!
Turning on the HTL-2
1
Actuate the operating switch (position I)
Z
The operating LED shines green
Z
The heating LED shines red
Z
The HTL hot plate is being heated
2
Wait until the heating LED extinguishes. Depending on
the temperature and the charging state of the SOLO
760 battery baton, this can take up to 10 minutes.
Z
The HTL-2 is ready for use.
