The Roll-Up III
34
Using the Tablet Configuration Utilities
If your application is not represented in the SuperSet Menu and does not
have a SuperSet Code, or if a different configuration is required, you can
use the Tablet Configuration Utilities to configure the Roll-Up III. The
Tablet Configuration Utilities replace the 24 switches that were associated
with older GTCO digitizers and the Custom Configuration Menu Card
used with the Roll-Up II.
To configure the Roll-Up III with the Tablet Configuration Utilities:
1
Make sure the Roll-Up III is plugged into a Serial Port, powered On,
and all the tablet drivers have been uninstalled or disabled.
2
Install the Tablet Configuration Utilities from the
Select Utility Software
to Install
section on the TabletWorks CD, or download them from
www.gtcocalcomp.com.
3
After the installation has completed, run the
Tablet Configuration
Utilities
from the
Programs
list under
GTCO CalComp TCU
.
4
The Tablet Configuration Utilities will begin searching the Serial Ports
for a supported tablet.
a) If the tablet is found, information about the tablet will display
under
Device Info
near the bottom of the screen.
b) If the tablet is not found, a message will appear under
Device Info
near the bottom of the screen.
i) If Wintab files were found, it is possible that the TabletWorks)
driver has the Serial Port open.
ii) If the Serial Port is open by another application, it will not be
displayed under
System Info
. Close any application, or uninstall
any driver that is using the Serial Port and select
Refresh System
Info
from the
File
drop-down list at the top of the screen. Click
on the Serial Port icon under
System Info
to search that Serial
Port.
5
Once the Roll-Up III has been found on a Serial Port, select
Advanced
Configuration
from the
Options
drop-down list at the top of the
screen.
a) If Advanced Configuration is not an option, make sure
Wintab
Compatible Driver
is not listed under
Device Info
.
The Tablet Configuration Utilities can use the TabletWorks driver
to
test
the tablet, but it must be communicating directly with the
tablet, via the Serial Port, in order to configure it.
The Tablet Configuration Utilities
