The DrawingBoard V
14
Tablet Customization
Selecting a Pre-Programmed Setup
There are three pre-programmed setups available with DrawingBoard V:
GTCO DP5 High Resolution Binary
Summagraphics MM 1201
CalComp 2000 ASCII
These setups are commonly used within software applications as required
tablet formats. They are stored in Save Areas
Default
,
2
, and
3
, respec-
tively. Check the manual that came with your software package to see if
your application requires one of these pre-programmed setups. The
Default
setup is available when you power on the digitizer.
To select one of the other setups:
1
Turn on Configuration Mode by clicking on the
Config/Exit
key.
2
Click on the desired
Restore
key.
3
Click on the
Config/Exit
key again to exit Configuration Mode.
The new setup is activated.
The following table lists the tablet options used by the pre-programmed
setups.
Point
Track
Run
Mode
9600
9600
9600
Baud Rate
7
8
8
Data Bits
Even
Odd
None
Parity
125 pps
150 pps
125 pps
Data Rate
200 lpi
500 lpi
1000 lpi
Resolution
Format 0
Format 30
Format 23
Output Format
CalComp 2000
ASCII
Summagraphics
MM 1201 Binary
GTCO DP5
High Resolution
Binary
Emulation
Default
Save 2
Save 3