Bit Pad Two 36
The ON and OFF positions are labeled on each switch. Set a slide switch by sliding it to the
desired position. Set a rocker switch by pressing down on the side next to the desired
position. Use a pointed instrument. Do NOT, however, use a pencil or another instrument
that could deposit residue, e.g. graphite or ink, on the switch. This could cause the switch
to malfunction.
2.
Adjust the Tilt or Use Flat
Bit Pad Two can tilt or lie flat. The tilt mounting is already attached to the back of
the tablet when shipped. It tilts four to six degrees or ten to 14 degrees, depending
on the position of the extenders.
For the tablet to lie flat, the tilt mounting must be removed and the four rubber feet
attached to the tablet bottom:
Slide the tilt mounting toward the edge of the tablet where the data/power
cable protrudes.
Summary of Contents for BIT PAD TWO DATA
