- 58 -
STS 1916 IPSR CT CI
—> The two configuration ports (CONTROL) are connected to the con-
figuration interfaces via an internal 100-BASE-T switch.
This switch does not have its own IP address.
You can use the
Hostnames
to call up the user interfaces without entering the
IP address. To do this, enter the
host name
followed by "
.local
" in the browser
(
e.g. gss.local
). If you operate several head stations in the network, you must
enter different names here.
If the connection to the gateway is interrupted for more than 3 minutes, the
device restarts for safety reasons! You can deactivate this monitoring with but-
ton
Check Gateway
.
—> Write down the IP addresses and the Host names! Further access to
the device is only possible via the IP addresses of the configuration
interfaces or the host names.
—>
If you have forgotten your IP addresses, you can reset the network
settings and the password by the reset button
(
3
—> For remote access it is important to setup a gateway with Internet
access.
—> Before leaving the menu, changes must be transferred to the head-
end station! Therefore click on button
.
—> After that
is displayed for a short time in the upper right corner.
—> Note about IPTVs: If you are changing an IP address and IPTVs are
"linked" on the old IP address for the service list of the head-end
station, you must import the changed path in the TV sets.
