ENGLISH
6
Starting up the satellite receiver
Your satellite receiver has been set at the factory for operation on universal LNBs in
Germany, immediately after it is switched on. After switching on the satellite receiver
we recommend adapting it to your personal requirements. If you wish to operate the
satellite receiver on a Unicable receiver system, you must set this as described in
chapter 8.5, page 29, before adapting it to your personal requirements.
For operation in other countries the satellite receiver must be reset to the factory set-
tings. This is necessary to prepare your satellite receiver for operation in your country
(s. chapter 6.4, page 14). We recommend subsequently adapting the satellite receiver
to your personal requirements.
—> Operation using a storage device (recording mode) is described from page
The following descriptions refer to the operation of your satellite receiver with the
remote control unless otherwise specified. The icons used correspond to the icons on
the remote control (s. page 10).
• Connect the power plug of the satellite receiver to the mains supply.
6.1 Switching
on
• Switching the television to AV mode.
• Switch on the satellite receiver using the mains switch “
” on the rear side of
the device (position
• Use the button on the remote control (s. page 10) or on the device
A
(s. page 8) to switch on from stand-by.
—> Control indicator in the stand-by button lights up in white.
6.2 Switching
off
• Use the
button on the remote control or on the device to switch it to stand-by.
—> Control indicator in the stand-by button lights up in red.
By using the mains switch on the rear side of the device, you can disconnect
the satellite receiver completely from the mains supply
(position
O
“
OFF
”)
.
