background image

Page 4 of 4

Model:

DIBC1224-1230

Unit 2, 110 Station Road, Seven Hills ,NSW,  2147, Australia

DIBC1224-1230-R3

Warranty Conditions:

 Our products come with guarantees that cannot be excluded under the Australian Consumer Law.

The customer is entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.

The customer is also entitled to have the products repaired or replaced if the products fail to be of acceptable quality and the failure does not amount to a major failure.
GSL Electronics (GSL) warrants that its products will, under normal use and service, be free of defects in material and workmanship for a period of three (3) years from 
the date of the original purchase by the customer as marked on the customer’s original invoice.
Please refer to our website for full warranty and return information which can be found at http://www.gsl.com.au/faq.html

The auxiliary battery is charged from the vehicle system when the engine is running. This is detected via 

the ignition wire.

The unit will automatically select Boost (12V) or Reducer (24V) mode depending on the vehicle’s voltage 

levels.

When the vehicle is off and the charger is drawing power from the solar panels, it will automatically use 

the solar regulator if the input is lower than 20W. Once the power increases to above 20W, to maximise 

efficiency the charger will automatically switch into MPPT mode. 

When the vehicle is not switched on and there is no daylight is available, the unit reverts to standby mode 

(<0.03A).

Typical Operation:  

Operational Chart : 

Summary of Contents for DIBC1224-1230

Page 1: ...er with solar input Dual mode solar controller utilises both PWM MPPT functions for maximum efficiency Output current 30A max Selectable output voltages for lithium sealed lead acid vented lead acid AGM or lead crystal batteries Over current temperature protections for extra product reliability Enhanced protection from moisture vibration and dust with full polymer encapsulation High efficiency typ...

Page 2: ...as monocrystalline polycrystalline and amorphous with 30W 300W Type A 14 4V generally suits gel AGM batteries Type B 14 6V generally suits lead and lithium batteries Type C 14 8V generally suits calcium and lead crystal batteries 1 Disconnect the battery supply 2 Choose a mounting position select a position with good ventilation where air can pass freely around the unit Avoid locations such as fue...

Page 3: ... connected to the vehicle chassis or the battery negative LED indication internal and external LED Basic Wiring Diagram To Ignition Switch of vehicle MODE SELECT Type A 14 4V Type B 14 6V Type C 14 8V LED Connector for optional DBM 12 DBM 12 Available in 5M or 10M Length LED Black Earth GND Red 12V Ignition Yellow Main Violet Auxilary Connector Wiring Colour Guide NOTE This connection is for outpu...

Page 4: ...e 3 years from the date of the original purchase by the customer as marked on the customer s original invoice Please refer to our website for full warranty and return information which can be found at http www gsl com au faq html The auxiliary battery is charged from the vehicle system when the engine is running This is detected via the ignition wire The unit will automatically select Boost 12V or...

Reviews: