GSi Agri-Alert 128 Touch, Installation And Configuration Manual

Page: 40 / 120

Chapter 6: System Configuration
3. Set the Auto arming parameters.
4. Set the Auto disarm parameters.
Configuring and Managing Modules
The main system has a total of eight inputs for zones. In order to add up to a total of 128 zones, modules
must be hooked up to the system. Once the modules are hooked up, they must be initialized for the
system to recognize them and make them available for zone configuration.
1. Click on Menu→System→Modules .
2. In edit mode, under the General tab, enter the module name.
3. Choose the module type.
4. Enter the module ID.
5. Under the Diagnostic tab, you can view the following statistics:
• Network errors since last reboot
• Number of coms in last 5 minutes
• Number of com errors in last 5 minutes
• Network error in last 5 minutes
6. To reset the statistics, click on the Reset Stats button.
Configuring and Monitoring Ethernet Data
The ethernet settings allow you to choose between a static or dynamic ethernet connection, or just view
the ethernet settings. You can also configure the system e-mail to enable the function of the system send-
ing an e-mail in the event of an alert.
Before You Begin
NOTE: If the ethernet icon is orange, the ethernet connection is bad.
1. Click on System→Settings→Ethernet settings.
2. In edit mode, under the General tab, click on the edit field next to the IP address field to bring up a 2
choice list.
3. Select either a static or a dynamic connection.
4. If you choose a dynamic connection, populate the following parameters:
• Subnet mask
• Default gateway
• DNS 1
• DNS 2
40 895–00677 Agri Alert 128 Touch