GSi Agri-Alert 128 Touch, Installation And Configuration Manual

Page: 21 / 120

3
Basic Connections
Topics Covered in this Chapter
▪ Preparing the Enclosures for Installation
▪ Relay Output Specifications
▪ Phone Line Connection Possibilities
▪ Mounting the Enclosures
▪ Installing and Connecting the Battery in the Battery Enclosure
▪ Connecting the Siren
▪ Connecting the Power Supply to a Power Source
▪ Connecting the Battery to the Main Enclosure
▪ Connecting the Battery Temperature Sensor
▪ Connecting a Sensor
▪ Connecting an External Microphone
▪ Connecting a Module to the Serial Bus Interface
Preparing the Enclosures for Installation
Preparing the equipment before mounting it to the wall facilitates manipulation and ensures all parts are
ready to be installed.
Before You Begin
You need a 10 AWG gauge wire to connect the main enclosure to the battery enclosure for the battery
supply. You also need a twisted pair wire and shielded wire with a minimum gauge of 20 AWG for the bat-
tery temperature sensor in the battery enclosure. The wires must be less than 36 inches long.
1. Close both the main enclosure and the battery enclosure.
NOTICE
Perforating the punch holes while the enclosures are open may crack the
enclosure.
2. Using a hole punch tool, perforate the punch holes needed for your installation at the bottom of each
enclosure.
3. Drill a hole the size of the your cable glands on the bottom right hand side of the main enclosure
4. Using the latches at the bottom of each enclosure, open them and remove the punched out
fragments.
5. Install the cable glands provided with your system to the bottom of each enclosure.
6. Close the main enclosure and the battery enclosure.
895–00677 Agri Alert 128 Touch 21