Chapter 6: Installing the Wet Bin
Installing the Belt Guard Cover
To easily remove the cover when performing maintenance to the drive belts and sheaves, you must install
the belt guard cover using its latches.
1. Insert the tabs on the belt guard cover into the slots on the belt guard body.
2. Engage the latches, one on the top and two on the bottom, refer to the
3. Install the dryer wet bin side that was left open to allow for easy access to the belt guard body.
Figure 6-8
Latches for the belt guard cover
Installing the Grain Intake Hopper
To ensure that the dryer receives the incoming wet grain, you must connect the grain intake hopper
between the dryer wet bin and the equipment that supplies the wet grain.
1. Locate the hopper assembly (D01-0193) over the grain intake opening at the top rear of the dryer.
2. Connect the hopper assembly to the dryer wet grain bin by using six 1/4 x 3/4 in. self-drilling screws
(S-6497), six 5/16 x 3/4 in. flange bolts (S-6606) and six 5/16 in. flange nuts (S-3611).
Figure 6-9
Hopper assembly and hopper installation location
9
Hopper assembly (D01-0193)
10
Hopper installation location on load auger assembly
42
PNEG-2132
Pressure Cooled Quiet Portable Dryer
