6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
60
PNEG-1451
Ladder, Safety Cage and Platform for Hopper Tanks
Intermediate Starter Bracket and Ladder Assembly with
Safety Cage
After drilling the two (2) 3/8" holes, attach the starter brackets (E) to the sidewall as shown in
.
Check the top ladder section to make sure the ladder rung dimples are to the top surface and attach to the
starter brackets (E) using the holes located 1" from the top of the ladder. See general detail information
for proper installation of additional ladder sections required. Standoff brackets (F) must be
installed on the ladder sections and attached to the sidewall at each horizontal seam (B) (repeating
every 32") until reaching the base platform. (Use 5/16" x 3/4" bin bolts for all connections.) In addition to the
two (2) field drilled holes in the sidewall for the starter bracket (E), it is also be necessary to field drill a
3/8" hole (A) in the ladder section for the starter bracket (E). Refer to the section in these instructions that
references the location of the base platforms.
Figure 6U
Ref #
Description
A
Field Drill 3/8" Hole for Starter Bracket
B
Horizontal Seam
C
Additional nuts required to support starter bracket and standoff brackets.
D
32" Typical
E
Starter Bracket (LDR-4346 - L.H and LDR-4347 - R.H.)
F
Standoff Bracket (LDR-4314)
G
4' Ladder Section
Summary of Contents for PNEG-1451
