6. 2.66" Corrugated Commercial Hopper Tank 10-22 Rings
54
PNEG-1451
Ladder, Safety Cage and Platform for Hopper Tanks
Eave Safety Cage Hoop Assembly
Before attaching any pieces to the ladders or platform, some pre-assembly is required. Attach two (2)
safety cage brackets (A) to the 8' extension rail (H) and one safety cage bracket (A) to the second 4' ladder
section (G) as shown in
. Bolt the safety cage hoop adjuster plates (C) onto the extension angle
. Using the proper configuration depending on the bin diameter (see adapter
assembly detail
), bolt the safety cage hoop adapters (D) together and attach to the safety cage
hoop halves. Be sure to use the 5/16" x 3/4" bolt with the head of the bolt to the inside of the safety cage.
Bolt these assemblies to the safety cage brackets (A) and hoop adjuster plates (C). (See connection detail
for proper hole location.) Tighten bolts as you go. The bottom assembly requires two (2) hoop
halves and will be positioned just below the platform as shown in
. Use the safety cage hoop
adjuster angle (B) to secure the two (2) hoop half (E) assemblies to the vertical entrance angle on the
platform assembly.
Figure 6L
NOTE:
48" Vertical supports removed in
for clarity.
Ref #
Part #
Description
A
LDR-4199
Safety Cage Hoop Bracket
B
LS-6776
Safety Cage Hoop Adapter Angle
C
LS-5285
Safety Cage Hoop Adjuster Plate
D
LS-5284
Safety Cage Hoop Adapters
E
LDR-4201
Safety Cage Hoop Half
F
LS-6775
67-1/2" Extension Angle (See extension angle hole detail
for proper installation.)
G
4' Ladder Section
H
8' Extension Rail
I
48" Typical Bottom to Bottom
Summary of Contents for PNEG-1451
