Grundig Toronto 55 CLE 6545 AL, User Instruction

Page: 84 / 95

83­
ENGLISH
»LNB Selection«: If more than one
satellites are used in the current SCR
system, select »1/2« to»2/2« for the
satellite corresponding to the relevant
positions using »
<
« or »
>
«.
– »LNB Power«: Set the LNB power to
»Off« or set it to »13/18V« or »14/19V«
depending on the LNB type by using »
<
«
or »
>
«.
Notes:
7
Use installation equipment supported / sug-
gested by your SCR Switch.
7
Other users / receivers connected to the
system may be affected if the specified user
band number and frequency is changed dur-
ing installation.
7
User band and user band frequency is speci-
fied on the SCR switch used; and each user
/ receiver must select a specified user band
and user band frequency.
7
With SCR satellite system, auto search by
several users / receivers at the same time
may cause problems.
– »DISEqC Mode«: Based on the number of
current satellite system, select the option
»Off« »DiSEqC 1.0« or »DiSEqC 1.1« with
»
<
« or »
>
«.
»Off«: For satellite systems with single
antenna.
» DiSEqC 1.0« switch allows for receiv-
ing from maximum four satellites at
the same time.
From »LNB selection« use »
<
« or »
>
to make the »1/4«, »2/4«, »3/4« or
»4/4« selection for the satellite that
corresponds to relevant DiSEqC posi-
tions.
» DiSEqC 1.1« switch allows for receiv-
ing from maximum sixteen satellites
at the same time.
SPECIAL­SETTINGS
­----------------------------------------------------------------------------------------
From »LNB selection« use »
<
« or
»
>
« to make the selections between
»1/16« and »16/16« for the satellite
that corresponds to relevant DiSEqC
positions.
8
Press »
EXIT
« to end the setting.
Motor­antenna­setup­­
(DiSEqC­1.2)
Your television supports DiSEqC 1.2 motorized
satellite systems. This feature allows to control
the satellite through your television.
1 Open the menu with » MENU «.
2
Activate the menu item »Settings« with
»
OK
«.
3 Select the menu item »Source Setup« with
»
>
« or »
<
« and press » OK « to confirm.
4 Select the line »Manual Channel Search«
with »
V
« or »
Λ
« and press » OK « to con-
firm.
5
Select the option »Satellite« with »
<
« or »
>
«
and press »
OK
« to confirm.
6 Activate the option »Antenna Settings« with
»

« (blue).
– The »Antenna Settings« menu is dis-
played.
7
Select the line »DiSEqC Mode« with »
V
« or
»
Λ
« and select »DiSEqC1.2« with »
<
« or
»
>
«.
– The line »DiSEqC 1.2 SETTINGS« is ac-
tive.
Note:
7
Additional operations are explained in the
following sections.
7
Settings regarding DiSEqC 1.2 are ex-
plained below. Contact an expert or your
dealer for DiSEqC 1.2 antenna systems.