5
ENGLISH
SAFETY AND SET-UP
-----------------------------------------------------------------------------------------------
MOUNTING
-----------------------------------------------------------------------------------------------------------------------------
Please note the following instructions when
mounting the stand floor.
7
The stand floor is designed for holding up
Ovation 3 hi-fi system. Any other use is ex-
pressly prohibited.
7
Only use the material supplied for mounting.
7
Tighten all screws hand tight.
7
Make sure the mains and antenna cables on
the base plate are fed out through the cable
opening on the bottom.
7
When using the stand floor, note that parquet
flooring and furniture is often coated with va-
rious types of varnish and plastic. Many of
these contain chemicals which can corrode
the feet of the stand floor, leaving marks on
the surface of the parquet flooring or furniture
which can be difficult or impossible to remove.
7
Be careful while mounting the stand floor,
some parts are heavy and may cause injury if
they accidentally fall down on you.
1
Connect the pipe to the base plate using the 4
thin screws.
2
Insert the mains and antenna/loudspeaker
cables (if required) into the pipe.
3
Place the Ovation 3 hi-fi system carefully front
down on a table on top of a suitable base,
such as foam.
Unscrew the screws and remove the stand.
4
Replace the socket to the back of the Ovation
3 hi-fi system by using the 4 screws supplied.
5
Insert the mains and antenna/loudspeaker
cables (if required) into the socket and take
them out from the foramen.
6
Insert the socket into the pipe. Tighten the
headless screw to fix the connection.
7
Always use the stand floor on an even, hard
floor.
7
Keep the stand floor away from children.
7
Connect the cables into the sockets of the
Ovation 3 hi-fi system.
Note:
7
Make sure the mains and antenna/
loudspeaker cables on the base plate are
fed out through the cable opening.
