Grundig GRA-D1104B, Owner'S Manual

Page: 36 / 136

NOTE: The images recorded in a low contrast scene such as at night can cause severe noise, triggering the
motion event too often. If this is the case, please reduce the nighttime sensitivity to a degree.
6.2.5. PTZ Settings
You can set the camera ID, protocol, baud rate and data transmission speed for each channel.
1. From <SYSTEM SETUP> - <CAMERA>, select <PTZ SETUP>.
2. Use the [
▲▼◄►
/ENTER] buttons of the remote control or mouse to set the address (ID), protocol and data
transmission speed for each channel.
3. To apply the change, click on <APPLY> in the bottom of the screen. Once clicked on the <APPLY> button after
changing the settings, a restarting message pops up. Click on <Yes> to restart the system automatically.
4. Once the setup is complete, press the [EXIT] button of the remote control or click on the <CLOSE> button on
the bottom to display a confirmation dialog. Click on <CANCEL> to return to the previous menu.
NOTE: Please refer to the user's manual of the camera for further details on setting the PTZ camera address,
protocol and baud rate.
6.3. Display Setting
You can configure here the display settings regarding the OSD menu, sequence and spot out.
6.3.1. OSD
Configure here the settings for the camera title, icon, status bar, timeline, border, username and language that
will be displayed on the screen.
34 English