5. Control Buttons
The control buttons are located on the right hand rear side of
the monitor.
6.1. Connecting using AV - Composite Video
Connect your video cable with BNC connector to the AV connector
on the rear of the monitor, and the other end to your
DVR/Camera etc.
If audio input is required, connect the 3.5 mm stereo audio cable
to the AUDIO INPUT on the rear of the monitor and to the Audio
Output connector on the DVR/Camera etc.
SOURCE
-
+
MENU
POWER
Connect power to the monitor and video source, and switch on.
Using the SOURCE button, press repeatedly until either "AV"
(depending on the connection used) is highlighted on the display
at
SOURCE: Selects the input mode – AV, HDMI, VGA.
MENU: Access to the On Screen Display (OSD) menu.
the top of the monitor's screen, and press "+" to select.
6.2. Connecting using HDMI
＋
and
－
: Volume control by up/down, confirms the input source
Connect one end of a HDMI cable (optional) to the HDMI connector
selection and navigates in the OSD.
POWER: Turns the monitor on or off.
6. How To Connect Your Monitor
Ensure all cable connections are secure - tighten all cable screws.
Movement and vibration may dislodge cables that are improperly
connected. Route all wiring and cabling away from any heat sources
and sharp metal edges to avoid damage.
on the rear of the monitor, and the other to the HDMI out
connector on the PC/DVR. This connection will support both video
and audio transmission.
Connect power to the monitor and video source, and switch on.
Using the SOURCE button, press repeatedly until "HDMI" is
highlighted on the display at the top of the monitor's screen,
and press "+" to select.
6.3. Connecting using VGA
Connect one end of a 15-pin monitor cable to the VGA connector on
the monitor and the other end to the PC/DVR.
Note: If your PC/DVR connector is not 15-pin D-sub you may need
an adapter to connect with this cable.
If audio is required, connect one end of the 3.5 mm stereo audio
cable (sometimes referred to as 1/8" stereo jack) to the PC Audio
IN
7
8
