Grundfos CONTROL MPC, Installation And Operating Instructions Manual

Page: 57 / 68

English (GB)
57
8.7.59 Units (4.5.2)
Fig. 110 Units
Description
Here you can select units for the various parameters.
Select between SI and imperial units. You can also select other
units for the individual parameters.
Setting range
Setting via control panel
• Settings > Functions, CU 352 > Units.
Set unit standard, measuring parameter and specific unit.
See the example in fig.
111 .
Fig. 111 Example of selection of units
Factory setting
The setting is done in the start-up wizard and depends on the
application.
Parameter
Basic setting
Possible units
SI Imperial
Pressure bar psi
kPa, MPa, mbar,
bar, m, psi
Differential pressure m psi
kPa, MPa, mbar,
bar, m, psi
Head m ft m, cm, ft, in
Level m ft m, cm, ft, in
Flow rate m
3
/h gpm
m
3
/s, m
3
/h, l/s,
gpm, yd
3
/s, yd
3
/
min, yd
3
/h
Volume m
3
gal l, m
3
, gal, yd
3
Specific energy kWh/m
3
Wh/gal
kWh/m
3
, Wh/gal,
Wh/kgal, BTU/
gal, HPh/gal
Temperature °C °F K, °C, °F
Differential temperature K K K
Power kW HP W, kW, MW, HP
Energy kWh kWh
kWh, MWh, BTU,
HPh
Note
If units are changed from SI to imperial or vice versa,
all individually set parameters will be changed to the
basic setting in question.