INTRODUCTION
The
GraverSmith
fulfills the need for a cost-effective
machine capable of allowing rapid cutting and carving
of metal, stone, wood, ivory and many other materials.
The easily controllable features of the
GraverSmith
also
makes it an ideal tool for stone setting, stippling, matte
finishing on jewelry, stipple engraving on crystals and
more.
The
GraverSmith
acts on the principle of an air-powered
hammer capable of delivering controlled impacts at speeds
of 400-8000 strokes per minute (handpiece dependant).
A foot pedal controls the impact power in much the same
way the gas pedal works on a car. The wide range of
power and control allows the user to freely move from
light to heavy cuts. To realize the full capability of the
GraverSmith
you need to become familiar with both the
operation and routine maintenance of your machine. This
manual is intended to help you master both the machine,
handpiece and the proper preparation of the graver.
GraverSmith
1 Rugged plastic carrying handle
2 Press type ON/OFF switch
3 5 micron filter and water trap
*NOTE: Will not remove oil from air
4 Air regulator with gauge
5 Handpiece port
6 Strokes per minute control
7 Compressed air supply IN
8 Compressed air supply OUT
9 Air input port (from filter)
10 Foot throttle port
2
3
4
6
5
1
8
9
10
7
FIG. 1
FIG. 2
