GRS GraverSmith 004-895, Operation And Maintenance Manual

Page: 12 / 12

GraverSmith™
Boxed Items Parts List
PART NO. DESCRIPTION
002-115 Square point graver
002-361 Barb fitting, 1/8 x 1/4
002-979 Steel point, small
004-050 6 ft. of #050-002 for foot control
004-519 Throttle assembly
022-053 Hex wrench, 1/8” Hex Key
022-404 #4 QC HSS Onglette Graver
022-872 Schuko adaptor 110 to euro 230
022-987 Power supply
022-993 115 power cord assy
044-069 6 ft. #050-029 black supply tube
WARRANTY
Each
GraverSmith,
including handpieces and foot control, carries a full 2-year
warranty covering parts and labor.
These products are designed for reliable operation using most sources of
compressed air. However, some air supplies contain excessive water, oil,
dirt, rust, or other contaminants. The unit’s built-in filter is a final filter to
protect against normal dirt and water. If your compressed air has excessive
contaminants, you should install the necessary filter(s) and water trap(s) ahead
of your unit.
Oil contamination can be gradual and subtle. If you notice an oil residue (usually
a yellow to brown colored sticky or liquid residue) in the unit’s filter bowl or
handpiece / throttle hose, you probably have an oil problem in your compressed
air. Older oil-lubricated and “silent” compressors that use internal oil are more
likely to cause oil contamination. If this occurs, install a Coalescing Oil Filter
(GRS #004-579 or equivalent).
NOTE: Damage caused by contaminated compressed air is not covered by
the warranty.
Glendo Corporation
900 Overlander Road
Emporia, KS 66801 USA
Toll-Free: 1-800-835-3519
Phone: 620-343-1084
Fax: 620-343-9640
E-mail: grs@grstools.com
www.grstools.com
GraverMach, GraverMax SC, GraverMax,
GraverMate, GraverSmith, BenchMate,
and Power Hone are registered
trademarks of Glendo Corporation.
USA and foreign patents
Printed in USA
All rights reserved.
© 2008, 2011 Glendo Corporation
Last Update: FEB 2011
LIT-307
Foot Throttle
#004-519 Parts List
PART NO. QTY. DESCRIPTION
001-028 2 Throttle Hinge Nut
001-036 1 Throttle Spring
002-065 2 10-32 x 3/8” RHMS
002-073 2 1/4-28 Nu
002-204 1 10-32 Hex Whiz Loc Nut
002-247 1 Washer
002-517 1 1/8” NPT x 0.170” Barb Fitting
002-526 1 Spring Retainer
002-527 1 10-32 x 3/4” RHMS
004-006 1 Throttle Base
004-007 1 Hinge Plate
004-008 1 Spring Retainer
004-009 2 Spacer
004-010 1 Pivot Shaft
004-011 1 Bleed Shaft
004-012 1 Outlet
004-031 1 Throttle Outlet Spring
004-459 1 Spring Retainer
011-210 4 Rubber Foot Assy. 8-32 x 3/8”
022-170 1 1/4-40 x 3/16” SHSS
022-553 1 10-32 x 1/4” RHMS