16
Revision date: 10.25.12
Complete these steps:
1. Locate the remaining 105234 slip tee fittings and the two (2) lengths of
straight pipe (105P094375).
2. Slide one fitting onto one straight pipe and slide that assembly onto the
handle of the main cover (A).
3. Secure the support pipe
to the slip tee fitting
using a Tek screw (B) to
prevent the pipe from sliding out of the fitting.
NOTE:
For proper operation, the fitting must be allowed to rotate on the
handle.
Do not attach the fitting to the handle
.
4. Repeat the procedure to install the other support pipe.
5. After installing both support pipes, open the top of the cold frame and use
the pipes to keep the top open as shown in the photo to the right.
6. Locate the black nylon straps. Loop one strap around the end rafter pipe
and attach it to the inside of the pipe using a Tek screw and washer (C).
7. Angle the doubled strap about 45 degrees, pull it snug and attach it to the
base frame using a Tek screw and washer.
NOTE:
Straps are attached on the inside of the frame at both ends of the
cold frame.
8
ATTACH SUPPORT PIPES AND STRAP
8. Attach the remaining strap to the opposite end of the frame using Tek
screws and washers (D).
9. Check the operation of the top and verify that all fittings are secured to the
pipes as previously described.
D
C
A
105234
105P094375
B
Tek Screw
The fitting must be
allowed to rotate on the
handle.
Do not attach the
fitting to the handle
.
Assembly Instructions