23
Revision date: 10.25.12
IMPORTANT:
The assembled cover
with the H-channel installed
must not exceed the inside
dimensions of the base frame for your cold frame.
Verify all measurements
before
cutting the PolyCor™. Measure from the center of one end
rafter to the center of the other end rafter and cut the PolyCor™ to that length. After cutting
the PolyCor™, install the H-channel and check the overall length.
If the cover is too long, it will bind within the base frame. Check for a proper fit. If needed,
remove the H-channel from one end, trim the cover, reinstall the channel and recheck the fit.
With the cover cut to size, attach it to the cover frame.
105146 SPECIAL NOTES:
In addition to the end pieces of H-channel, the 105142 cold
frame includes a center section of H-channel. The section of H-channel connects the two
separate pieces of PolyCor™ during the installation.
With the two sections of PolyCor™
cut to size, connect them using the center piece of H-channel. Install the end pieces of
H-channel and attach the assembled cover to the frame.
Front
105145
8' W x 5' H x 8' L
Assembled Cover including
H-Channel must not exceed
96" (outside-to-outside).
Front
105144
8' W x 5' H x 6' L
Assembled Cover including
H-Channel must not exceed
74" (outside-to-outside).
Cover Frame
Vinyl H-channel used
at the splice of the
main cover material
Front
105146
8' W x 5' H x 12' L
Width of both cover panels must be cut
so that the middle section of H-channel
is centered as shown (if desired).
Assembled Cover including H-Channel must
not exceed 146" (outside-to-outside).
ATTENTION:
The length, width, and height dimensions
are approximate.