33' Doorway Installation
7 of 12
Left and Right Upper Pentagon Glazing Panels
13
14
15
Trim a notch in the glazing panels around Side Rafter Supports.
Use a circular saw or jigsaw with plywood blade. Make sure to
use eye and ear protection. Attach with 1-1/2" ss screws.
Note: Do not attach bottom edge until Step 14 is complete.
Mark & trim top
edge & corner
of panels
Tape Seams and Attach Bottom Cap
Tape the vertical and horizontal seams with 2" 8672 tape.
Find the bottom cap with no holes and slide it on the exposed
polycarbonate edge above doorway, with long side towards
the exterior of the dome. Attach to Horizontal Glazing Support
with (4) 1-1/2" ss screws. Finish attaching bottom edge of
Upper Pentagon Panels.
tape
here
bot
tom
ca
p
tape
here
Ridge
16"
Begin by screwing upper portion of middle rafters onto Ridge,
approximately 16" from angled edge. Adjust placement so that
ridge is level, and make a mark on the glazing. Run a level
vertically to get a plumb line against the front edge of the ridge
and make a mark. Remove the assembly and cut the front
edge of the ridge. Place the rafter and ridge back using the mark
that indicated level. Screw the bottom portion of the middle Rafters
to the Side Rafter Supports. Use 2-1/2" screws as shown.
2 1/2"
Screws
Mark
Ridge
Here
Mark
Glazing
Here
Cut out here
(before removing
protective film)
