![background image](http://html1.mh-extra.com/html/grone-0/2536-840600/2536-840600_operating-instructions-manual_2269698019.webp)
19
Replacing the Saw (Wheel) Blade
WARNING:
Make sure that the on/off switch is in the “off ” posi-
tion and the saw is unplugged or otherwise it can cause serious
injuries.
1.
Unscrew 3 thumb screws (E) and remove the blade guard.
2.
Remove the blade lock knob (left thread) using two
wrenches (provided in the set: 30 mm and 12 mm).
3.
Remove the outer fl ange and the worn-out wheel
(carefully).
4.
Put a new wheel on the axle spindle and make sure that
the wheel rotation direction is clockwise.
5.
Place the outer fl ange and the lock knob on the saw axle
spindle and tighten the blade using wrenches 12 and
30 mm.
6.
Put the blade guards again.
7.
Check the distance between the blade and the blade
guards.
Make sure that the blade does not touch the blade
guards.
Make sure that the water pipe does not touch the
blade wheel.
8.
Tighten 3 thumb screws on the guards which must be
always mounted when the machine is working.
Operation
Cutting at 90°
1.
Fill the tray with water.
The water pump must be immersed all the time.
2.
Using the bevel, check the angle which is between the
saw blade and the work table.
If it is not 90°, adjust it by tightening slightly two hex-
agonal bolts (F) on the supporting rod.
3.
Clamp the workpiece on the table.
Put the end of the workpiece on the guide support-
ing rod.
4.
Plug in the power cords.
5.
Switch on the machine, check the water supply and if
necessary, adjust it using the water knob on the blade
guard.
Make sure that water is sprayed on both sides of the
saw blade.
Bevel cutting
1.
For bevel cutting, the head can be tilted at angle be-
tween 0° and 45°.
2.
Loosen two spring knobs (H) on the supporting rod and
adjust the head to the required angle.
Next, tighten both spring knobs.
Now, cut in a normal way.
Pily_stolowe_GTTS_Full_v04_HR.indd 19
Pily_stolowe_GTTS_Full_v04_HR.indd 19
2016-10-19 03:21:02
2016-10-19 03:21:02