Groen TDB, Operator'S Manual

Page: 11 / 28

OM-TDB 11
OM-TDB
11
CAUTION
DO NOT OVERFILL THE KETTLE WHEN
COOKING, HOLDING OR CLEANING.
KEEP LIQUIDS AT LEAST 2-3” (5-8 cm)
BELOW THE KETTLE BODY RIM TO
ALLOW CLEARANCE FOR STIRRING,
BOILING PRODUCT AND SAFE
TRANSFER.
WARNING
WHEN TILTING KETTLE FOR PRODUCT
TRANSFER:
1) WEAR PROTECTIVE OVEN MITT AND
PROTECTIVE APRON.
2) USE DEEP CONTAINER TO CONTAIN
AND MINIMIZE PRODUCT SPLASHING.
3) PLACE CONTAINER ON STABLE, FLAT
SURFACE, AS CLOSE TO KETTLE AS
POSSIBLE.
4) STAND TO LEFT OR RIGHT OF KETTLE
(DEPENDING ON HANDLE PLACEMENT)
WHILE POURING — NOT DIRECTLY IN
POUR PATH OF HOT CONTENTS.
5) POUR SLOWLY, MAINTAIN CONTROL
OF KETTLE BODY HANDLE AT ALL
TIMES, AND RETURN KETTLE BODY TO
UPRIGHT POSITION AFTER CONTAINER
IS FILLED OR TRANSFER IS
COMPLETE.
6) DO NOT OVERFILL CONTAINER. AVOID
DIRECT SKIN CONTACT WITH HOT
CONTAINER AND ITS CONTENTS.
CAUTION
KEEP FLOORS IN FRONT OF THE KETTLE
WORK AREA CLEAN AND DRY. IF SPILLS
OCCUR, CLEAN AT ONCE TO AVOID
SLIPS OR FALLS.
Common Accessories
1. Lift Off Cover
As with stock pot cooking, an optional lift
off cover can speed up the heating of
water and food products. A cover helps
retain heat in the cooking vessel and
reduces the amount of heat and humidity
released into the kitchen. Use of a cover
can reduce some product cook times
and help maintain the temperature, color
and texture of products being held or
simmered for extended periods.
Make sure the plastic ball handle is
secure on the lift off cover before using.
ALWAYS use the plastic handle to place
or remove cover from the kettle.
Wear protective oven mitts and a protective
apron.
When putting the cover on the kettle, position
it on top of kettle rim, with its flat edge facing
the pouring lip.
WARNING
AVOID ALL DIRECT CONTACT WITH HOT
SURFACES. DIRECT SKIN CONTACT
COULD RESULT IN SEVERE BURNS.
AVOID ALL DIRECT CONTACT WITH HOT
FOOD OR WATER IN THE KETTLE.
DIRECT CONTACT COULD RESULT IN
SEVERE BURNS.
When removing cover:
a) Firmly grasp plastic handle
b) Lift rear edge (farthest from operator) 1-
2” (3-5 cm) to allow any steam and water
vapor to escape the cooking vessel.
Wait 2-3 seconds.
c) Tilt cover to 45-60° angle and allow any
hot condensate or product to roll off
cover back into kettle.
d) Remove cover, ensuring that any
remaining hot condensate or product
does not drip on operator, floor or work
surfaces.
e) Place cover on safe, flat, sanitary, out-
of-the-way surface, or return to kettle
rim. Cover
may also
be placed
in the
optional
holder for
the cover
as shown
in the
photograph.
Lift the rear of the lid first.
OM-TDB
11 11
OM-TDB 11