OM/SM-HY-3E & HY-5E(CE)
13
Once the cavity has cooled, reach in and
remove the fan baffle partition by lifting it
upward and drawing it toward the center of
the cavity.
Pour two cups of Groen de-liming solution or
Lime-Away into the de-liming port.
Steam Generator and Cooking Chamber
The steamer cavity and steam generator may be
cleaned separately. When cleaning is scheduled, or
if the SERVICE light is on, follow these simple de-
liming instructions.
REMEMBER: DON’T ALLOW
DE-LIMING AGENTS TO MIX WITH DE-
GREASERS.
a.
Set the timer to OFF position.
b.
Turn off the steamer for five
minutes.
c.
Open the door and allow the
cavity to cool.
d.
After the cavity has cooled five minutes, make
sure that the fan has stopped and remove the
fan baffle partition by lifting it up and toward the
center of the cavity.
e.
Wipe out the cavity.
Make sure the drain
holes at the back of the cavity are clear of
debris.
f.
Hold down the CLEAN button while turning the
steamer on. Continue holding the CLEAN
button until the CLEANING indicator
light comes on. Then release the
button. After five minutes, the
beeper will begin to beep rapidly.
This is the signal to add
Groen
Delimer Descaler
(P/N 114800)
,
Lime-A-Way® or equivalent.
g.
Replace fan baffle partition and
close door.
h.
The cleaning cycle consists of a
boiling clean
stage, a
soak
stage,
and a
rinse
stage.
The full cycle
takes about 50 minutes to
complete.
i.
WEAR PROTECTIVE GLOVES AND EYE
PROTECTION FOR THIS STEP. When the
steamer beeper sounds, turn off the steamer
and open the door. After the fan has stopped,
remove the fan baffle partition and rinse it well in
a sink. Wipe out the cavity completely. If
necessary, use a damp nylon pad.
j.
Reinstall the fan baffle partition.
k.
If the steamer will no longer be used, leave it off.
Otherwise, wait 10 minutes and turn it back on.
When the READY light comes on, the steamer
is ready for normal operation.
If the SERVICE light stays on after Steam
Generator Cleaning:
a.
Check that the water supply is on and that the
supply hose is not kinked. With the problem
corrected, turn the steamer off for 10 seconds
and then re-start.
b.
Repeat steam generator cleaning procedures.
