OM/SM-HY-3E & HY-5E(CE)
32
11. Remove steam generator from rear of
steamer by lifting steam generator up and
out.
To Install:
12. Transfer all fittings, heater element, safety
valve, high and low water level probes to
new steam generator from old generator or
use new fittings as needed. Refit the
insulation on generator.
13. Carefully wrap the thermal blanket onto the
steam generator. Make sure it fits snugly,
with no air spaces between the blanket and
the steam generator. Fasten seams with alu-
minum duct tape.
14. Fit the steam generator into position from
the back of the steamer. Fasten the steam
generator using the four 1/4-20 kep nuts.
15. Connect all hoses to the steam generator
fittings and tighten their respective hose
clamps.
16. Connect the probe terminals to the high and
low level probes. Make sure the rubber
boots are securely positioned on the
terminals after connection.
17. Connect the high temperature thermostat
housing to the steamer bracket.
R. Door Removal/Installation/Alignment
P/N 094150
WARNING
DISCONNECT THE POWER SUPPLY BEFORE
BEGINNING ANY SERVICE PROCEDURE.
1.
To remove the door, turn off the steamer
power and allow it to cool. Then, remove
door by supporting the weight of the door
and remove hinge pin.
2.
Place the door on a flat, clean table or
similar support, with Steamer Door gasket
facing up. Be careful not to scratch door
surface.
3.
Inspect door gasket for signs of cuts or other
defects which may impair its function.
Replace if necessary. See Section U.
To Install:
4.
To install the door, apply NEVER-SEEZ
lubricant to hinge pin. Align door with hinge
and insert hinge pin, or apply service
removable Locktite 242 to the door-to-hinge
bolts, then install door and mounting bolts.
Do NOT tighten mounting bolts at this time.
5.
Place a piece of masking tape over the door
pin (bullet) hole in the door/U-channel.
6.
Close the door until the door pin just
penetrates the masking tape. Make sure the
door pin contacts only the door latch spring.
7.
If door pin does not strike the center of the
masking tape or spring hole in the U-
channel, loosen the hinge-to-steamer bolts
and align the door to the door pin. Tighten
hinge-to-steamer mounting bolts.
8.
You should be able to pull a piece of paper
smoothly between the gasket and steamer
cavity with the door closed. To adjust the
hinge side, loosen the door-to-hinge bolts
and align the door gasket with the steamer
cavity. Tighten the door-to-hinge mounting
bolts. To adjust the bullet side, refer to
Section X.
9.
Operate steamer and check for leaks.
S.
Door Switch
P/N 096857
WARNING
DISCONNECT THE POWER SUPPLY BEFORE
BEGINNING ANY SERVICE PROCEDURE.
1.
From the right side of the steamer with panel
removed, unplug the door switch from the
electrical board.
2.
The switch (for normal door opening) is held
in place with two small screws. With a
slotted screwdriver, remove these screws
and the switch may be removed.
