OM-CC-G
25
NOTE
: For double stacked ovens, wait five minutes
after starting the first oven before you refill
the fill tank with de-limer for the second
oven. The first oven should read “CL:40" or
less before you add delimer for the second
oven (See step 5, below).
e.
Step 5
— Cooking Chamber and/or De-
liming
Close the oven door and press START. The
display will now read “CL:45," and the colon
[:] will blink once each second. The unit will
begin an automatic sequence that involves
heating, draining and refilling the steam
generator at various time intervals. This
Clean Cycle takes in 45 minutes. The
display will count down each minute.
NOTE: To exit the Clean Cycle at any time press
and hold the CLEAR touch pad for three
seconds.
After halting the Clean Cycle, and before you
cook any food in the unit, be sure to wash
out all chemical residue thoroughly, by filling
and draining the steam generator. (Enter the
Steam Mode and wait 60 to 90 seconds to
fill; enter the Oven Mode, take the unit out of
all modes or simply turn it off to drain). Wait
at least three minutes before restarting the
unit.
Also wipe chemical residues from the
cooking chamber with a wet, clean cloth
before you cook.
Rinse the cloth often
.
This cleaning must include both sides of the
four removable partitions, the racks, and the
tubes and walls behind the partitions. The
racks and partitions may be rinsed in a sink.
f.
Step 6
— Cooking Chamber and/or De-
liming
When the Clean Cycle is complete, the
display will read “00:00.”
WARNING
UNIT MAY BE HOT ENOUGH TO BURN YOU.
DO NOT TOUCH HOT SURFACES.
g.
Step 7
— Cooking Chamber and/or De-
liming
Before you use the unit for cooking, wipe the
entire interior with a clean, wet cloth.
Rinse
the cloth often
. This cleaning must include
both sides of the four removable partitions,
the racks, and the tubes and walls behind the
partitions. The racks and partitions may be
rinsed in a sink.
WARNING
DO NOT OPERAT E THE UNIT IN ANY MODE
UNLESS ALL FOUR REMOVABLE PARTITIONS
HAVE BEEN RETURNED TO T HEIR PROPER
LOCATIONS.
i.
Step 8
—Cooking Chamber and/or De-
liming
If the unit will not be used right away, leave
the door open long enough to allow the
chamber to dry completely.
E.
Errors During Cleaning
If the timer stops and the SERVICE light stays
on, there has been an error which prevents the
unit from completing the clean cycle. Take the
following steps:
1)
Reset the unit. Reenter “99." The display
should read “CC” or “CL.” Press START.
2)
If the unit fails again to complete its clean
cycle, call your authorized Groen Service
Agency.
F.
Clean Cycle Counter
The unit tracks the total number of clean cycles
completed. To check this total, first turn off the
unit. Press and hold the 0 touch pad while
turning on the unit. The total will be displayed in
the timer window. This counter cannot be reset.
