OM-CC-G
16
h.
Press the numbered touch pads to set the
cooking time. The time will appear in the
Time Display Window. If you enter the
wrong number, press the
CLEAR
touch pad
to erase the time from the display, and enter
the time again.
i.
When the correct cooking time has been
entered, press the
START
pad. The colon in
the display will blink and the time will count
down the cooking time. (The unit must be
READY
before the timer can count down.
j.
If you open the door during the cooking
period, steaming and the timer will stop (but
will not reset). When you close the door,
steaming and timing will continue.
WARNING
WHEN YOU OPEN THE DOOR STAY AWAY
FROM ANY STEAM COMING OUT OF THE UNIT.
STEAM CAN CAUSE BURNS.
k.
When the timer reaches zero, it stops steam
generation and sounds a beeper. Water in
the steam generator stays at its standby
temperature (200
o
F - 93
o
C). On older
models, the beeper will sound until the door
is opened or
CLEAR
is pressed.
l.
Carefully open the door. If the food is
cooked, remove the pans using hot pads or
oven mitts to protect your hands.
m. After the display has counted down to zero
opening the door or pressing
CLEAR
once
will reset the display to the time that was last
used. Pressing
START
will repeat the cook
cycle. If the same cooking time will be used,
you only need to press the number keys
when you first set that time.
n.
After the display has counted down to zero
you can reset the time to zero by either (1)
opening the door
and
pressing
CLEAR
or
pressing
CLEAR
twice. A new cooking time
may then be set by using the number keys.
2.
Oven Mode
a.
To use the Convection Combo™ as a
convection oven, switch on the electric power
by pushing the
ON
touch pad. (If the
SERVICE
light comes on when you turn on
the power, see the Troubleshooting section).
If the door is closed and the cooking
temperature is above 200
o
F (93
o
C) the fan
will begin to operate.
b.
If the power is already on, and there is a
number in the time display, press
CLEAR
one or more times to reset the time to zero.
NOTE:
You cannot change operating modes
while the timer is running
c.
The unit will power up in the mode in which it
was last used. Because of this, the indicator
light for that mode will be lit. If the unit is not
already in the Oven Mode, press the
OVEN
touch pad. The
OVEN
light will come on and
the oven fan will operate.
d.
Use the Temperature Control Knob to set the
desired cooking temperature, which will
appear in the temperature display. Unless
the cooking chamber is already at or above
the selected temperature, the unit will start
heating and the
WAIT
light will come on.
e.
If the unit was recently used at a
temperature 15
o
F (8
o
C) or more over the
selected temperature, the
HOT
and
WAIT
lights will come on. The unit can be cooled
quickly to the desired cooking temperature
by leaving the door open or following the
Fast Cool procedure described near the end
of this section (Paragraph 5).
f.
The
READY
light will indicate when the oven
is at the desired temperature.
g.
Load the food into the pan or pans in a
uniform layer.
