-26-
Model T32002 (Mfd. Since 02/20)
1. Install bit into collet.
2. Grasp tool firmly.
3. Turn tool ON.
4. Ease tool against workpiece using light
pressure.
Note:
Always test bit on a scrap piece of
material similar to workpiece.
Using Rotary Shaft
5. Hand-tighten collet nut while pin wrench is
inserted into locking hole.
Failure to wear safety glasses while operat-
ing grinder could cause serious personal
eye injury.
Figure 19. Tightening rotating shaft collet.
Tool Bit
Shaft
Pin
Wrench
6. Tighten one-third of a turn with collet wrench
(see
Figure 19). DO NOT over tighten.
Summary of Contents for T32002
Page 36: ......
