Model T28360 (Mfd. Since 11/18)
-23-
Squaring Fence to
Blade Path
5. Repeat Steps 2–3, adjusting fence as neces-
sary until blade remains in full contact with
square, then re-tighten hex nuts.
The following procedure aligns the right fence
perpendicular to the blade path, and ensures the
right and left fences are parallel.
Item(s) Needed
Qty
Open-End Wrench or Socket 10mm ................. 1
Large Square ..................................................... 1
To square fence to blade:
1. DISCONNECT MACHINE FROM POWER!
2. Place short side of square against right fence
and long side of square against blade (see
Figure 23).
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
3. Slide saw carriage along length of guide
rods, looking for smooth, consistent contact
between blade and edge of square.
— If blade remains in contact with square for
entire length of guide rods, then fence is
square to blade path. Proceed to
Step 6.
— If blade loses contact with square or nudg-
es square out of alignment, then fence
must be squared. Proceed to
Step 4.
4. Loosen hex nuts that secure right fence to
table (see
Figure 24).
Figure 24. Location of right fence hex nuts.
Figure 23. Square placed against right fence
and blade.
Right
Fence
Long Edge of
Square
Short Edge of
Square
Right
Fence