-18-
Model T28360 (Mfd. Since 11/18)
4. Slide saw back and forth to make sure it does
not bind on rails.
5. Secure tile on table using fence, miter gauge,
and hold-down bracket.
6. Connect machine to power and turn ON.
7. Ensure an adequate amount of water is
spraying onto blade, then make cut.
Installing/Changing
Blade
The Model T28360 uses abrasive continuous-rim
blades. This type of blade does not cut and wear
like typical "toothed" blades. To maintain the opti-
mal cutting capability of your tile saw, the blade
should be changed when the abrasive portion of
it has worn away or becomes glazed over and
dressing is not an option.
5. Hold arbor in place with arbor wrench (see
Figure 14), then loosen and remove arbor
with socket wrench (see
Figure 14).
Item(s) Needed
Qty
Tile Saw Blade (
Grizzly Part # T30312) ........... 1
Phillips Head Screwdriver #1 ............................. 1
Bucket ................................................................ 1
To install/change a blade:
1. DISCONNECT MACHINE FROM POWER!
2. If necessary, drain water from tray by pulling
drain plug.
3. Move saw carriage to open end of tray (see
Figure 13).
4. Remove blade guard, as shown in Figure 13.
7. Replace and tighten arbor.
8. Replace blade guard.
6. Install or replace blade (see Figure 15).
Make sure rotation arrow on blade matches
arrow on blade cover.
Flange
Bolt
Flange
Arbor
Blade
Figure 15. Blade installation order.
Figure 13. Removing blade guard.
Blade
Guard
installing/changing blade
Figure 14. Removing blade.
Arbor
Socket
Wrench
Rotation
Arrow
Arbor
Wrench