-18-
Model T27710 (Mfd. Since 04/16)
21. Refer to Kohler engine manual to select
required engine oil type, locate fill plug (see
Figure 24), and fill engine with required oil.
22. Refer to Kohler engine manual to select
required fuel type, locate gas cap (see
Figure 24), and fill engine with required fuel.
17. Remove plastic cap from hydraulic filter fitting
(see
Figure 23), and lubricate and install (1)
17 x 2.5mm O-ring on end of fitting.
18. Unthread plastic plug from low pressure
return hose (see
Figure 23).
19. Install low pressure return hose onto tank
hydraulic filter fitting (see
Figure 23), making
sure O-ring stays in place.
Note: Tighten hydraulic hose connector to
18-20 inch/pounds.
Figure 24. Engine gas cap and oil fill plug
locations.
Gas Cap
Damage caused by running log splitter
without hydraulic fluid or engine oil will not
be covered under warranty.
20. Make sure log splitter is on level surface, and
fill hydraulic tank with hydraulic fluid. Refer to
Checking/Adding Hydraulic Fluid on Page
29 for specific details.
IMPORTANT: Hydraulic tank is shipped from
factory without hydraulic fluid. It must be filled
before operation!
Figure 23. Low pressure hose and oil filter
fitting.
Low Pressure
Return Hose
Hydraulic
Filter Fitting
Oil Fill Plug
Summary of Contents for T27710
