Grizzly T27710, Owner'S Manual

Page: 17 / 118

Model T27710 (Mfd. Since 04/16)
-15-
Assembly
To assemble log splitter:
1. Wipe dab of multi-purpose grease onto spin-
dle and wheel bearing (see Figure 10), and
with valve stem facing outward, slide wheel
onto axle until it stops.
2. Place 20mm flat washer with M20-2.5
slotted hex nut onto axle, then place 4 x
36mm cotter pin through hole in spindle end
(see
Figure 10).
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To make sure the assembly pro-
cess goes smoothly, clean all parts that have any
heavy-duty rust preventative applied by the fac-
tory (if applicable).
Flat Washer 20mm
Cotter Pin
4 x 36
Spindle
Axle
Wheel
Bearing
Axle Cap
Valve Stem
Slotted Hex Nut
Figure 10. Installing wheel onto axle.
3. Bend both cotter pin tangs so wheel is held
onto axle, and tap axle cap (see
Figure 10)
onto wheel.
5. Pull lock pin out and pivot support leg until pin
locks leg in down position (see Figure 11).
6. Attach front frame tube with support leg to
rear frame tube with (2) M10-1.5 x 70 hex
bolts, (2) 10mm flat washers, and (2) M10-1.5
lock nuts (see
Figure 12).
Front
Frame
Tube
Rear Frame Tube
Hex Bolt M10-1.5 x 70
Flat Washer 10mm
Lock Nut M10-1.5
Figure 12. Installing front frame tube onto rear
frame tube.
7. Place frame tube onto hydraulic tank and
attach it with (4) M12-1.75 x 35 hex bolts, (4)
12mm flat washers, and (4) M12-1.75 lock
nuts, as shown in
Figure 13.
Frame
Tube
Hydraulic
Tank
Hex Bolt
M12-1.75 x 35
Flat Washer 12mm
Lock Nut
M12-1.75
Figure 13. Installing frame tube onto tank.
Support Leg
Lock Pin
Figure 11. Support leg locked in down position.
4. Repeat Steps 1–3 to install the other wheel.