Grizzly MTS 30-10 E2, Translation Of The Original Instructions For Use

Page: 101 / 196

101
GB
Observe the following points in particular:
• Check the cutting tools for damage
and wear.
• Correct installation of the cutting head
• Easy movement of all switches
• Secure sit of the spark plug connector.
If the connector is loose, sparks can
be formed and thus ignite any leaking
fuel-air mix.
• Ensure the handles are clean in order
to be able to guide the equipment
safely.
• All safety and protective devices must
be properly installed and in place be-
fore the equipment can be started.
The cutting head must be able to run
freely.
Before starting the equipment, ensure that
the cutting head is sitting correctly and
that the moving parts are free.
Warning! If there is any doubt,
seek help with the operation of
this equipment from a specialist in
an authorised service centre.
Putting on the Carrying Strap
(Picture 9)
Always wear a shoulder strap
when working with the equipment.
Always switch off the equipment
before loosening the shoulder
strap. Risk of accidents.
The carrying strap is equipped
with a quick-release device.
Pulling the red lug (28a) relea-
ses the device quickly from the
carrying strap in a dangerous
situation.
1. Put on the carrying strap (28).
2. Adjust the strap so it fits tightly.
3. Adjust the strap so the spring clip (39) is
around 10 cm below the hip.
4. Fix the spring clip onto the lifting ring (23)
on the shaft tube of the equipment.
Unhook the equipment before start -
ing the engine and fix it to the carry -
ing strap with the engine running.
pic. 9
28
28a
39
23
Starting the Engine (Picture 10)
Start the engine at least three me-
tres from the filling location
1. Ensure that the protective cap on the
thread cutter (see picture 7, no. 14) has
been removed.
2. Place the device on a stable, level
surface. Make sure that the cutting tool
does not affect objects or the ground.
3. Set the on/off switch (40) on the switch -
ing element (22). .
4. For a cold start, set the choke lever (4) to
the „ cold start “. position.
For a warm start, leave the choke lever
(4) in the „ warm start “. position.
5. Press the fuel pump 6 x (see picture 1,
no. 7).
6. To use the half-throttle lock, simultane-
ously press the throttle lock (41), the
throttle lever (42) and the gas-locking
knob (43) on the handle. Then release