Grizzly H8178, Owner'S Manual

Page: 11 / 28

Model H8178 Power Feed
-9-
Inventory
After all the parts have been removed from the
crate, you should have the following items shown
in
Figure 2 :
Contents Qty
A.
Limit Switch Assembly ............................... 1
B. Power Feed Unit ......................................... 1
C.
Power Cord ................................................. 1
D. Left and Right Feed Stops ....................1 Ea
E.
Cap Screws M6-1 x 16 (Power Feed) ........ 2
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
Figure 2.
Inventory.
B
C
E
D
A
Installation
These instructions cover the power feed instal-
lation for the Grizzly Model G0463 and G0619
small mill/drills. Follow these steps carefully, and
your power feed installation should be quick and
trouble free.
To install the power feed:
1.
DISCONNECT THE MILL FROM POWER!
2.
Loosen the gib screw lock nuts (
Figure 3
),
and adjust the X-axis table gib screws, so the
table moves with slight resistance as felt in
the handwheel.
Note: Make your adjustments on all four
locations equally and in small increments.
Figure 3. X-axis gib adjustment.
3. When properly adjusted, tighten the lock
nuts.