-42-
Model G4003G (Mfd. Since 1/15)
The steady rest supports long, small diameter
shafts and can be mounted anywhere along the
length of the bedway.
Familiarize yourself with the steady rest compo-
nents shown in
Figure 49 to better understand
the controls.
Steady Rest
Tools Needed
Qty
Hex Wrench 3mm .............................................. 1
Open-End Wrench 10mm .................................. 1
Open-End Wrench 19mm .................................. 1
To install and use steady rest:
1. DISCONNECT LATHE FROM POWER!
2. Thoroughly clean all mating surfaces, then
place steady rest base on bedways so trian-
gular notch fits over bedway prism.
3. Position steady rest with base clamp where
required to properly support workpiece, then
tighten hex nut shown in
Figure 49 to secure
it in place.
Figure 49. Steady rest components.
Set Screw &
Jam Nut
Finger
Adjustment
Knob
Finger
Roller
Hex Nut
Clamp
Knob
4. Loosen clamp knob that secures the two
halves of steady rest and open top portion,
as shown in
Figure 50.
5. Loosen jam nuts and set screws so finger
roller positions can be adjusted.
6. Use finger adjustment knobs to position bot-
tom two finger rollers against workpiece.
7. Close steady rest, then use finger adjustment
knobs to adjust all three finger rollers so that
they just touch the workpiece without causing
deflection.
Note:
The finger rollers should properly sup-
port the workpiece along the spindle center-
line while still allowing it to freely rotate.
8. Lock fingers with set screws and jam nuts,
then tighten clamp knob.
Note: To reduce the effects of friction, lubricate
the fingers with way oil during operation.
Figure 50. Workpiece mounted in the steady
rest.
Summary of Contents for G4003G
Page 108: ... 106 Model G4003G Mfd Since 1 15 ...
Page 112: ......
