Model G4003G (Mfd. Since 1/15)
-21-
14. Remove headstock end cover to gain better
access to the headstock base pedestal (see
Figure 15).
Figure 15. End cover removed to expose
headstock pedestal mounting points.
Headstock Pedestal
Mounting Points
15. Make sure lathe bedway is level side to side
and front to back and, if necessary, shim
between lathe pedestals and chip pan (refer
to
Leveling on Page 22 for detailed informa-
tion).
16. Insert (6) M12-1.75 x 40 hex bolts with (6)
6mm flat washers through pedestals and chip
pan, then thread them into cabinet tops.
Note: For best results, recheck the ways in
24 hours to make sure they are still level and
have not twisted. Reshim as required.
Figure 16. Locations to secure back splash.
x 4
17. Apply a bead of silicone around each of the
base pedestals where they contact chip tray,
to further reduce possibility of fluids leaking
into cabinets.
18. Attach back splash to rear of lathe with (4)
M6-1 x 10 Phillips head screws and (4) 6mm
flat washers, as shown in
Figure 16.
Summary of Contents for G4003G
Page 108: ... 106 Model G4003G Mfd Since 1 15 ...
Page 112: ......