-44-
G1021X2 & G1021Z (Mfd. Since 08/16)
figure 55. Example of infeed roller bushing
block and height adjustment controls.
roller
Bushing
Block
Jam nut
& Set Screw
9. repeat Steps 7–8 on left side of infeed roller.
10. re-check both sides of infeed roller and, if
necessary, make further adjustments until
infeed roller height from side-to-side is 0.040"
below BdC of cutterhead knife, then retighten
both jam nuts.
11. Keeping same "0" reference on rotacator
dial from
Step 5, repeat Steps 7–10 for out-
feed roller, but adjust it until it is 0.020" below
BdC of cutterhead knife.
8. loosen jam nuts and use set screws on each
side of feed roller as shown to adjust height
of infeed roller bushing block until rotacator
dial shows 0.040", which is the recommended
distance for infeed roller below cutterhead.
figure 56. Example of adjusting chip breaker
height.
adjustment Jam nut
& Set Screw
13. re-install belt cover, top cover, drive chain
cover, and dust port.
12. using same "0" reference on rotacator
dial from
Step 5, perform similar steps as
described previously to adjust height of chip
breaker to its recommended specification
given at beginning of this subsection. the
adjustment controls are shown below.
Summary of Contents for G1021X2
Page 76: ......
