Grizzly G1021X2, Owner'S Manual

Page: 18 / 76

-16-
G1021X2 & G1021Z (Mfd. Since 08/16)
NOTICE
if you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
inventory
the following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
if any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
box 1 (figure 5) Qty
A. planer unit (not Shown) ............................. 1
b. dust port .................................................... 1
c. Cast-iron Extension tables (g1021X2) ...... 2
D. roller Extension tables (g1021z) .............. 2
E. table Elevation handwheel ........................ 1
tools and hardware (figure 6)
f. open-End Wrenches 10/13, 12/14mm .1 Ea.
G. hex Wrenches 3, 4, 6mm ....................1 Ea.
h. Set Screws M8-1.25 x 12 (Ext. tables) ..... 6
i. Flange Bolts M6-1 x 12 (dust port) ............ 6
J. Key 4 x 4 x 10 (handwheel) ....................... 1
K. loW/high direction label (handwheel) ... 1
L. handwheel handle (handwheel) ............... 1
M. hex nut M10-1.25 (handwheel) ................. 1
N. Flat Washer 10mm (handwheel) ............... 1
B
d
C
E
figure 5. Box inventory.
LOW HIGH
F
g
h
i
J
K
l
M
n
o
p
Q
r
S
t
u
V
figure 6. tools and hardware.
figure 7. tools and hardware (g1021X2 only).
figure 8. tools and hardware (g1021z only).
G1021X2 Only (figure 7)
O. hex Bolts M8-1.25 x 25 (Ext. tables) ........ 6
P. Flat head torx Screws #10-32 x
1
⁄
2
" .......... 5
Q. indexable Carbide inserts 15 x 15 x 2.5 .... 5
R. torx Bits t-25 ............................................. 2
S. torx t-handle Wrench
1
⁄
2
" .......................... 1
G1021Z Only (figure 8)
t. hex Bolts M8-1.25 x 20 (Ext. tables) ........ 6
u. Flat Washers 8mm (Ext. tables)................ 6
v. Knife-Setting Jig ......................................... 1