Model G0855/G0856 (Mfd. Since 02/19)
-23-
Switch
Cord
Figure 19. Switch pedestal attached to stand
and cords connected.
Switch
Pedestal
Matching
Plugs
Motor
Cord
Switch
Pedestal
20. Slide handwheels onto leadscrews, and
secure with pre-installed 5/16"-18 x 1/2"
Phillips head screws and 5/16" fender wash-
ers (see
Figure 21).
Figure 21. Handwheel secured to leadscrew
(1 of 2).
Handwheel
(1 of 2)
Leadscrew
(1 of 2)
x 2
21. Verify outfeed table height is set correctly
with knives/inserts at top dead center (TDC)
(refer to
Setting Outfeed Table Height on
Page 48) and all knives/inserts are securely
tightened in cutterhead.
19. Install dust port with (4)
1
⁄
4
"-20 x
1
⁄
2
" Phillips
head screws and (4)
1
⁄
4
" flat washers (see
Figure 20).
Figure 20. Dust port installed.
x 4
17. Attach switch pedestal to stand with (2)
M8-1.25 x 20 cap screws and (2) 8mm lock
washers (see
Figure 19).
18. Connect switch cord to motor cord (see
Figure 19).
Note: The switch cord and motor cord have
matching plugs for easy connection.
