-20-
Model G0855/G0856 (Mfd. Since 02/19)
Assembly
Figure 12. Lifting slings properly positioned.
3. Remove top and sides of wood shipping
crate, then place small items aside in safe
location.
4. With help from another person, remove fence
assembly, including belt cover, from table
assembly and set aside in safe location.
5. If lifting table assembly without power lifting
equipment, lift table assembly off shipping
pallet with help of three people and carefully
place it on top of stand. Proceed to
Step 7.
IMPORTANT: Tighten table locks to prevent
damaging tables.
6. If lifting table assembly with power lifting
equipment, attach lifting slings to table
assembly, as shown in
Figure 12, and care-
fully place it on top of stand.
This jointer is equipped with a mobile base to
allow moving and placing of machine without
power lifting equipment. DO NOT attempt to lift or
move jointer without necessary assistance from
other people. If using power lifting equipment
(such as a forklift or crane), each piece of lifting
equipment must be rated for
at least 600 lbs. to
support dynamic loads that may be applied while
lifting.
Review the
Power Supply section (see Page 13),
then prepare a permanent location for the jointer.
NOTE: Do not destroy cardboard box or
wood shipping crate and packaging until after
Test Run.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble jointer:
1. Open cardboard box and place stand upright.
2. Tighten mobile base lock knobs (see Figure 2
on
Page 4) to secure stand in position.
HEAVY LIFT!
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
